RUSP build, page 12, stage 4

Discuss building, using, and modifying the Rotary Un-Smartphone.
Post Reply
S_Bang
Posts: 2
Joined: Fri Jan 26, 2024 12:13 pm

RUSP build, page 12, stage 4

Post by S_Bang »

Hi. I have a question as to the fastening of the bell arm to the daughterboard, the kit was a couple of m2 screws short, but after locating two spare ones (tip- check all boxes and drawers, chances are some might just hang around in the corners buried in fluff) I have noticed that the daughterboard has nylon washer and nut prefixed, is this an upgrade on the daughterboard that deviates from the manual, or am I in some other way daft? So no nylstop nut on this one?

As an aside, really good project to do with both young and adult kids, the cool wonkiness of this project captivates their attention!

Cheers, sturla
S_Bang
Posts: 2
Joined: Fri Jan 26, 2024 12:13 pm

Re: RUSP build, page 12, stage 4

Post by S_Bang »

ok, found the answer further down the list, thanks : )
viewtopic.php?t=98
Post Reply