First order went great and looking forward to making it spin

Discuss using and implementing the NearZero motor controller and the RoboWheel hubmotor.
Post Reply
JimD
Posts: 1
Joined: Sun Dec 06, 2020 9:39 pm

First order went great and looking forward to making it spin

Post by JimD »

Hi all:
This is my first forum post. I ordered one NZ1 and one RoboWheel as a first test. All went smoothly with the order and the products look great. I plan to start with a bench test setup of the RoboWheel to measure the torque output at various operating voltages and currents. I will share those results. I've got lots of plans after that. Looking forward to it. Thanks Justine!
JimD

justine
Site Admin
Posts: 38
Joined: Sun Feb 23, 2020 2:34 am

Re: First order went great and looking forward to making it spin

Post by justine »

Cool beans, Jim. Thanks!

HaroldW
Posts: 1
Joined: Fri Mar 19, 2021 2:12 am

Re: First order went great and looking forward to making it spin

Post by HaroldW »

Do you have any results on Robowheel torque vs voltage tests I am interested in knowing the max torque at low speeds?

Post Reply